Hitachi RPC-1.5FSN3 Installation And Operation Manual page 26

INDOOr UNIT INSTALLATION
14 indoor unit installation
!
d a n G e r
• Do not install the indoor unit in a flammable environment to
avoid fire or an explosion.
• Do not put any foreign material into the indoor unit and check to
ensure that none exists in the indoor unit before the installation
and the test run. Otherwise, a fire or failure, etc. may occur.
14.1 factory-suPPlied accessories
Check to ensure that the following accessories are packed with
the indoor unit.
The hose clamp, screws, washers and cord clamps are put in
the pipe insulation.
Suspension bracket
Washer
Pipe insulation
(large)
Pipe insulation
(small)
Cord clamp
(large)
Cord clamp
(small)
Drain hose
Hose clamp
Insulation
Installation and operation manual
24 PMML0254A rev.4 - 12/2018
accessory
• Check to ensure that the wall is strong enough. If not strong
enough, the indoor unit may fall down on you.
• Do not install the indoor unit outdoors. If installed outdoors, an
electric hazard or electric leakage will occur.
?
n o t e
• If any of these accessories are not packed with the unit, please
contact your contractor.
• The remote control switch, the branch pipes and the transition wires
are optional accessories which are not included with the indoor unit.
Q'ty
2 For mounting indoor unit
8 For suspension bracket
1
For refrigerant piping connection
1
6 For fixing insulation
1 For fixing plug
1 For connection drain pipe
2 For connecting drain hose
2 For drain hose connection
1
Purpose
-