Table 1-5. Standard Settings - Hitachi CM827U User Manual

Standard Settings
Microprocessor-based user preset functions can store 32 sets of geometry settings. The
following industrial standard settings have been pre- programmed by the factory.

Table 1-5. Standard Settings

No. Video Mode Name
(with Resolution and Vertical Frequency)
1
VGA
2
VESA
3
1024 ×
VESA
4
1152 ×
VESA
5
1152 ×
Mac
6
1280 ×
VESA
7
1600 ×
VESA
8
1600 ×
VESA
9
1856 ×
NOTE:
* Input signals with approximately the same frequencies may be regarded as the same
signal.
* The following horizontal timing conditions are recommended (at sync. H, V separate or
H/V composite).
for 31 kHz - 55 kHz horizontal frequency:
Horizontal front porch should be more than 0.1 µs.
Horizontal sync. width should be within 1.0 - 3.8 µs.
Horizontal back porch should be more than 1.2 µs.
Horizontal blanking width should be more than 3.5 µs.
for 55 kHz – 107 kHz horizontal frequency:
Horizontal front porch should be more than 0.1 µs.
Horizontal sync. width should be within 1.0 - 3.0 µs.
Horizontal back porch should be more than 1.1 µs.
Horizontal blanking width should be more than 2.4 µs.
* The following vertical timing conditions are recommended.
Vertical front porch should be more than 10 µs.
Vertical sync. width should be less than 200 µs.
Vertical back porch should be more than 400 µs.
Vertical blanking width should be more than 450 µs.
* In case the front or back porch is extremely long, or the data display time is extremely
short, it may not be able to set the expected size and position.
1 - 20
640 ×
400 - 70 Hz
800 ×
600 - 85 Hz
768 - 85 Hz
864 - 75 Hz
870 - 75 Hz
1024 - 85 Hz
1200 - 75 Hz
1200 - 85 Hz
1392 - 72 Hz
SPECIFICATIONS (Continued)
Horizontal Frequency
31.47 kHz
53.67 kHz
68.68 kHz
67.50 kHz
68.68 kHz
91.15 kHz
93.75 kHz
106.25 kHz
102.95 kHz