1
2
Figure 10
1. Bulkhead fitting (wire
attached)
2. Outlet (bottom of the tank)
E. Move the bulkhead fitting into position making
sure that the flanged gasket seats against the
interior wall of the rinse tank
F. Secure the bulkhead fitting to the rinse tank with
a plastic flange nut
Note: Remove the wire from the bulkhead fitting.
1
2
Figure 11
1. Rinse tank sump
2. Bulkhead fitting
(positioned)
G. Install a 90° barbed fitting onto the bulkhead
fitting and secure the barbed fitting with a retainer
(Figure
12).
Note: Rotate the 90° barbed fitting so that it
faces rearward.
3
G014229
3. Filler cap
(Figure
10)
3
G014230
3. Plastic flange nut
1
1. Retainer
2. Bulkhead fitting
2. Release the 2 latches that secure the guard behind the
seat to the chassis and remove the guard from the
machine
(Figure
1. Guard
3. Remove the 2 flanged locknuts at the carriage bolts
at the upper-inboard hole of the left-and right, front
tank straps.
4. Align the rinse tank to the sprayer tank as shown in
Figure
14.
9
G014260
2
3
Figure 12
3. 90° barbed fitting
13).
Figure 13
2. Latch