Page 2
• Connect the sensor to your Computer with a USB Cable using the Config Port. • Use the TCR Command line interface to set your LoRa keys: parametric.ch/docs/tcr/tcr_cli_v10x www.parametric.ch/product/tcr...
Page 3
Clicking the three dots (2) sets the default settings. Extended Warranty Available leads you to the Parametric Store to upgrade your device’s warranty. Always press ‘Save’ after changing settings. www.parametric.ch/product/tcr...
Page 4
Send uplinks with ACK requests. LinkCheck Interval After this interval, send LinkCheckReq with next uplink. Set to zero to disable Linkcheck completely. DevEUI, AppEUI, AppKey Enter your LoRaWAN Keys Payload Type Choose between Parametric and Cayenne LPP compatible payload formats. www.parametric.ch/product/tcr...
Page 5
If enabled, the sensor will measure up to 20 objects passing by. Then the radar sensitivity will be set automatically. Speed Class 0 … 3 Adjustable speed classes ranging 80km/h … 120km/h. Radar Sensitivity [%] You can set the radar module from 10% (sensitive) to 100% (very sensitive). www.parametric.ch/product/tcr...
AWG (0.2 – 0.75mm • Guide the cable through the cable gland. • Before closing the casing, make sure that the two components are aligned as depicted. • The cable gland is pointing downwards and should be fastened to ensure water protection. www.parametric.ch/product/tcr...
2 screws. • Optional MT40 tiltable pole mount needs to be attached to the TCR-S. Optimal Placement TCR are 1D sensors measuring Traffic along a virtual line. The device can be directed horizontally or with a tilt up to -40. www.parametric.ch/product/tcr...
• RTL LED blinks when traffic detected from right • LTR LED blinks when traffic detected from left If both LEDs are blinking, the device is trying to connect to the LPWAN. Parametric GmbH Waldeggstrasse 82 3800 Interlaken Switzerland www.parametric.ch...