1. Manuals
  2. Brands
  3. Trusted Clean Manuals
  4. Floor Machine
  5. TPL-BK-17-TC
  6. Owner's/operator's manual

Trusted Clean TPL-BK-17-TC Owner's/Operator's Manual

Low speed and dual speed floor machine
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

FOR MODELS:
TPL-BK-17-TC
TPL-BK-20-TC
TPL-BK-17VS-TC
TPL-BK-20VS-TC
LOW SPEED AND DUAL SPEED
FLOOR MACHINE
OWNER'S/OPERATOR'S MANUAL
WWW.CLEANFREAK.COM
888-722-5508
REVISED 9-6-22

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TPL-BK-17-TC and is the answer not in the manual?

Questions and answers

Related Manuals for Trusted Clean TPL-BK-17-TC

Summary of Contents for Trusted Clean TPL-BK-17-TC

  • Page 1 FOR MODELS: TPL-BK-17-TC TPL-BK-20-TC TPL-BK-17VS-TC TPL-BK-20VS-TC LOW SPEED AND DUAL SPEED FLOOR MACHINE OWNER’S/OPERATOR’S MANUAL WWW.CLEANFREAK.COM 888-722-5508 REVISED 9-6-22...
  • Page 2 UNPACKING YOUR NEW EQUIPMENT: WARNING! When your package is delivered, check each of the 3 cartons carefully for signs of rough handling. If the • Do not operate the machine unless trained and au- EQUIPMENT is damaged, notify the carrier immediate- thorized.

  • Page 3: Proper Lifting Techniques

    • All servicing of CLEANFREAK equipment should be 4. Slowly begin straightening your legs, lifting slowly. performed by an CLEANFREAK authorized service Never twist your body during this step. center. 5. Once the lift is complete, keep the object as close to •...

  • Page 4: Preparing The Machine For Operation

    til machine is resting on handle. Center the pad on the FINAL ASSEMBLY INSTRUCTIONS: pad holder and place the pad onto the pad holder. TO REMOVE PAD: Simply remove the pad from the PLEASE READ MANUAL COMPLETELY BEFORE pad holder by pulling it away from the pad holder with PROCEEDING TO FINAL ASSEMBLY INSTRUC- steady force.
  • Page 5 • Wrap the cord around the left side handle grip. • Do not wrap too tightly. FINAL ASSEMBLY INSTRUCTIONS: PLEASE CHECK THAT YOU HAVE RECEIVED 3 CARTONS. EACH CARTON IS MARKED, AS FOL- LOWS: 1. BASE ASSEMBLY 2. HANDLE ASSEMBLY 3.
  • Page 6 5. Open the handle carton and set the handle nearby the 8. Insert the pivot axle screw (C22558) through the motor base. handle bracket and the handle pivot tube. Hand tighten the nut (C13100) to the pivot axle screw and finish by tightening with a wrench.
  • Page 7 3. Insert the locking clamp handle/spade bolt assembly 6. Place the handle in the down position to check the through the Cord Hook Clamp assembly (located on the locking function. If too tight, unlock the handle and loos- handle) and the left and right handle braces ( D11481, en the nut (C11558) slightly.

This manual is also suitable for:

Tpl-bk-20-tcTpl-bk-17vs-tcTpl-bk-20vs-tc

Table of Contents