Trusted Clean TPL-SS-17-TC Owner's Manual & Parts List

Trusted Clean TPL-SS-17-TC Owner's Manual & Parts List

Low speed floor machine
Hide thumbs Also See for TPL-SS-17-TC:

Advertisement

Quick Links

LOW SPEED FLOOR MACHINE
OWNERS MANUAL & PARTS LIST
This equipment is intended for commercial use only
TPL-SS-17-TC
1-888-722-5508

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TPL-SS-17-TC and is the answer not in the manual?

Questions and answers

Summary of Contents for Trusted Clean TPL-SS-17-TC

  • Page 1 LOW SPEED FLOOR MACHINE OWNERS MANUAL & PARTS LIST This equipment is intended for commercial use only TPL-SS-17-TC 1-888-722-5508...
  • Page 2 WHEN THE MACHINE IS DELIVERED Check the carton carefully for signs of rough handling. Remove the machine from the carton. If the machine is damaged, notify the carrier IMMEDIATELY and request an inspection. Be sure to keep the carton, packing inserts, packing lists and carrier’s receipt until the inspector has verified your claim. CleanFreak’s liability ceases when the carrier picks up the shipment but our customer service staff will be glad to furnish any information needed in connection with the claim and will expedite repair of the machine.
  • Page 3 WARNING (Continued) • Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord. • Do not handle plug or appliance with wet hands. • Make sure the machine is plugged into an electrical outlet with the same voltage and frequency rating as shown on the nameplate of the machine.
  • Page 4 PREPARING THE MACHINE FOR OPERATION Your floor machine will operate in a wide variety of hard floors and carpet cleaning applications. Consult with your local dealer or CleanFreak’s Customer Service to select the correct accessories for the job you are going to perform. BRUSH AND PAD DRIVER INSTALLATION WARNING: Make sure the power cord is disconnected from the electrical outlet before...
  • Page 5 MACHINE OPERATION 1. Install the pad driver and pad, brush or attachment. 2. Plug in machine. 3. Lower the handle to the desired operating position. 4. Place both hands on the handle grips with your fingers around the on/off lever which extends from one side to the other underneath the handle grips. 5.
  • Page 7 POWER CORD, 14-3, 50 FT, SJTW K11498-BLUE GRIP, BLUE C11528 SCREW, 10-32 X .25IN H12066 LABEL, 1.5 HP H11908 LABEL, TRUSTED CLEAN D11496C SWITCH BOX COVER, CHROME H11493 LABEL, SAFETY, FLOOR MACHINE C11529 SCREW, 10-32 X .375 IN K11519 LEVER GRIP, LOCKOUT, BLACK...
  • Page 8 NOTES REVISED 01/25/2013...

Table of Contents