Speco D4VX User Manual page 30

Item
Alarm Out/
Alarm Duration
Digital Deterrent
Controller & PTZ
Spot-Out
Site
Motion Zone
Motion Sensitivity
Key Tone
Figure 4.4.1. Device Setup Screen
Table 4.4.1. Menu Items in Device Setup Screen
Set the sensor, motion, and video loss for triggering alarm relay
HDD Error and Video Loss can trigger beeping
.
Setup schedule and audio recordings for Digital Deterrent.
Set the PTZ baud rate, protocol, and ID.
CVBS Out is can be used as Composite Video Output or Spot-Out
depending on the Sub Monitor Out of Display setup menu.
(Spot-On Event on/off, Spot Event Dwell Time, Sequence On/off, Sequence
Dwell Time, Spot Channel) *The last image will keep on the screen until the
next event occurred.
Select specified channel for motion zone setup.
Select either Full Zone or Partial Zone for motion detection.
Press the right button of mouse to exit from Motion Zone grid screen.
Set the motion sensitivity for the selected channel.
Control the motion sensitivity from 1 to 9.
(1 – Lowest sensitivity, 9 – Highest sensitivity)
Enable/disable key tone.
Description
30