E) Temperature Unit; Measurement Mode; A) Millivolt; B) Voltage - VOLTCRAFT VC MFK-2000 Operating Instructions Manual

e) Temperature unit

Press to select TEMPERATURE UNIT, then press

9. Measurement mode

If the calibrator is in "Output" mode, press

a) Millivolt

Press to measure millivolt. Refer to the figure below for connecting the test leads.
Millivolt measurement

b) Voltage

Press to measure the voltage. Refer to the figure below for connecting the test leads.
Voltage measurement

c) Continuity

Press to measure the continuity. Refer to the figure below for connecting the test leads.
Continuity measurement
Note: The buzzer beeps if the resistance is less than 250 Ω.
36
to set temperature unit.
to switch to "Measurement Mode".
Connection
Connection
Connection