Pelsue BC-08A Product Manual page 15

3. Installation of a #FT-C70 Fall Arrest Tower on the #BC-08A Angle Beam Clamp
a. Install the #BC-08A Angle Beam Clamp per the instructions in Step #2 of section 5.2 of this manual.
b. After the #BC-08A has been completely installed, remove the pin from the base of the fall arrest tower.
c. Place the fall arrest tower onto the #BC-08A, center the base of the tower between the base lugs present on the
angle beam clamp (Refer to Fig. 5.2f).
d. Align the holes of the fall arrest tower base with the holes of the base lugs on the #BC-08A and replace the tower's
retaining pin (Refer to Fig. 5.2g).
e. Adjust the levelling pegs in order to make the tower vertical (Refer to Fig. 5.2g). ! WARNING ! - The #FT-C70 fall
arrest tower can only be used for the anchoring of personal fall arrest systems when placed in a vertical position!
f. Utilize the installed fall arrest tower within the limits of and according to the instructions provided within the Model
#FT-C70 fall arrest tower's product manual.
Figure #5.2f: #BC-08A & FT-C70
Installation
#501126-001 - Product Manual: Model #BC-08A Adjustable Angle Beam Clamp - Revision 00 - Date: 12-03-2009
Top Mount
Figure #5.2g: #BC-08A & FT-C70
!WARNING! - The orientations shown above are the
only two approved configurations in which the FT-C70
Fall Arrest Tower can be installed and utilized.
!WARNING! - The FT-C70 Fall Arrest Tower utilized in
conjunction with the #BC-08A Angle Beam Clamp must
be installed according to its product manual, and utilized
by a qualified individual in order to retain its stated rating
& compliance.
!WARNING! - Any FT-C70 Fall Arrest Tower Attached to
the #BC-08A Angle Beam Clamp must be utilized within its
published limits and capabilities. The rating of the installed
tower may supersede or derate the capabilities of the #BC-
08A beam clamp.
5.2 - Product Installation & Set-up (continued)
Leveling
Pegs
Hitch
Pin
Base
Lugs
Installation
Edge Mount
Figure #5.2h: #BC-08A & FT-C70
Completely Installed
Page 15