English - Harry Gestigkeit SG 1 Operating Instructions Manual

E N G L I S H
Before using the heater compare the voltage required on the identification
plate with the available mains voltage. It is absolutely necessary to unwind
the connection cable completely. Insert the safety plug only into an earthed
socket.
1.) SWITCHING ON
The heaters have a single button operation. As soon as the button has left
the zero marking, the yellow control lamp illuminates.
2.) STEPLESS TEMPERATURE REGULATION
(types SG.. and SGK.., SH 85 and SH 15)
An energy regulator switches the heating on and off in controlled periodical
intervals. The higher the setting on the knob the longer the heating intervals.
The setting '12' is at 100% capacity. The settings 1 to 12 should help to find
established data once more. The green control (only SG.. and SGK..) lamp
indicates heating and non-heating intervals.
3) Contacter - Outlet
This appliance can either be used with a normal electronic contact
thermometer (e.g. EBRO GFX 393, Ikatron ETS 3, etc.) or a mercury-
contact thermometer.
If a contact thermometer is not being used then the Dummy
Connector (which is included) must be plugged in.
The Dummy Connector acts as a safety contact between 3 and 5) This
impedes further heating should the plug accidentally be removed while
being used with a contact thermometer.
When using the hotplate with a contact thermometer, the hotplate
temperature should be accordingly higher adjusted. Should the required
temperature shown on the contact-thermometer not be reached then this
is normally due to the fact that the hotplate temperature has been set too
low. Please ensure that the temperature-limiter is also accordingly set at
a higher temperature.
7