Indicator And Working Status Description - Etec EKEC Series User Manual

3.4 Indicator light and working status description
State
No. LED Color
Code
0 K Red
1 A Blue
2 I Blue
3 B Blue
4 B Blue
5 C Green
6 D Red
7 F Red
8 H Red
9 E Red
10 G Blue+Red
Red+Green
11 J
+Blue
12 L Blue
13 M Red+Green
LED State
Power self detect failed
5Hz flashing
1Hz flashing
2Hz flashing
CP connect to diode+2.7KΩ
Stabilization
CP connect to diode+1.3KΩ
Stabilization
CP connect to diode+2.7KΩ
Green
parallelconnect1.3KΩ
brightening
CP connect to diode+2.7KΩparallelconnect1.3KΩ
parallel connect 270R or CP connect to diode+270R
Stabilization
Or CP connect to diode+270R parallel connect 2.7KΩ
Or CP connect to diode+270R parallel connect 1.3KΩ
CP line short circuit with PE line
1Hz flashing
RCMU occurs residual
5Hz flashing
current or self detect failed
(Requirement waiting the CP
2Hz flashing
PP line disconnection
2Hz flashing
Electromagnetic Lock failed
2Hz flashing
5Hz flashing
1Hz flashing
DLB Mode activated
PE、CP、PP state
CP disconnection
Waiting for IC card
Diode short circuit
disconnected)
IC card failed
Circuit overload，
-08-
Controller
Remark
state
Power self-check
failed!Please turn
Fault--1#
the power back
on!
Ready
RFID
Waiting
Connected
Connected
Charging
Fault--2# Need Ventilation!
CP- PE short
circuit!
Fault--3#
Please check the
CP line
RCMU leakage or
Fault--4# self-inspection
failure
EV-Charing
Fault--5#
Socket Fault
SPLIT PP wire，
Fault--6# Please check the
PP line
Electronic Lock
Fault--7#
Disabled
RFID card is not
Fault--8#
valid
Circuit overload，
Fault--9# DLB Mode
activated