Appendix 6 - Instructions For The Use Of - Datamate M80 Series Manual

APPENDIX 6 – INSTRUCTIONS FOR THE USE OF
1. Before engaging, the slot on the jackscrew should be at right angles to the length of the
connector.
2. Push the connectors together. Once the connectors are mated, use a screwdriver to push
down onto each 101Lok Jackscrew until the spring is compressed. Turn the Jackscrew 101
degreess, and release. The Jackscrew should remain partially compressed.
3. To disengage, use a screwdriver to push down on each 101Lok Jackscrew until the spring is
compressed. Turn the Jackscrew anti-clockwise 101 degrees, and release. The Jackscrew will
spring back to its uncompressed position.
COMPONENT SPECIFICATION
- 15 -
JACKSCREWS
C00525 C00525
C00525 C00525