Appendix 2 - Coax Contact Details - Datamate M80 Series Manual

APPENDIX 2 – COAX CONTACT DETAILS
A2.1. COAX INTERFACE DIMENSIONS
A2.2. COAX ASSEMBLY INSTRUCTIONS – M80-305/306/307, M80-315/316/317
1) Strip cable to dimensions shown against relevant part (see appropriate engineering drawings).
Inner Insulator
Inner Conductor
2) Identify pieces of coax connector to be assembled.
Body
3) Slide sleeve onto cable past stripped area.
4) Crimp contact to end of cable inner conductor.
Contact
5) Insert cable and contact into coax body from back end – make sure that the braid goes outside and
over the end section.
6) Slide sleeve back over the end of the coax body and the braid. Crimp into place on the cable
insulation, using a hexagonal crimping tool.
COMPONENT SPECIFICATION
Male
Crimp here
Body
- 10 -
Female
Outer Insulator
Braid
Contact
Sleeve
Braid
Crimp here
C00525 C00525
C00525 C00525
Sleeve