Setting The Dialing Mode - ClearSounds CSC40 Installation Manual & User Manual

SETTING THE DIALING MODE

Set the dial mode switch located on back of the phone to "T" if you have Touch Tone
service or "P" for Pulse dialing if you have rotary dialing service. The default is set to "T"
dialing switch mode. Please check with your local telephone company if uncertain of the
type of service.
(See diagram #2)
INTERNATIONAL PULSE SPEED SWITCH
Set the International speed switch located on back of the phone to "300 mS". The
default is set to 300mS
PHONE MOUNTING INSTALLATIONS
Make sure you have a modular wall jack near the place you have chosen to install the
telephone. If you have an older phone jack, you will need to buy a modular jack adapter.
Desk / Table Use
1. Connect one end of the 6ft telephone cord to the line jack on the back of your
CSC40 Phone and connect the other end to a modular phone jack (RJ11C).
2. Connect the handset coil cord (curly cord) to the handset and to the telephone.
3. Lift the handset and listen for a dial tone. If you hear a dial tone, you phone is ready
to use. If there is no dial tone, check all your cords to make sure they are plugged in
securely.
DIAGRAM #2 – Dialing mode switch
. The 100 mS is used in the UK.
(See diagram #3)
DIAGRAM #3 – International speed switch
7