Dust Extraction; Connection Of The Power Supply - Mac allister 64 77 19 Original Instructions Manual

MSSP120
Improtant!
The protective cover (2) must always be
lowered over the workpiece before cutting.
The protective cover (2) must be in positi­
on at all times to prevent contact with the
blade.

Dust extraction

Notes on dust emission
The dust emission values measured according to the "Guidelines for the
test of dust emission (concentration parameter) for wood processing machi­
nes" by the technical wood committee are below 2 mg/m3. Thus, a consis­
tently safe compliance with the TRK threshold value for wood dust applica­
ble in the Federal Republic of Germany can be assumed when connecting
the machine to a proper extraction device with an air speed of at least 20
m/s
WARNING!
Attach a dust extraction device when using
this product in order to keep the working
area clean!
Wear a dust mask when operating this pro­
duct. Dust can be harmful to your health!

Connection of the power supply

1. Connect the pulg with a suitable socket.
2. Your porduct is now ready to be used.
WARNING!
Check the voltage!
The voltage must comply with the informati­
on on the rating label!
Dust extraction
GB
25