Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Fransgard DM-2050
Summary of Contents for Fransgard DM-2050
- Page 1 Manual Fransgård DM-2050 Disc mower From serial number : → 57050001...
- Page 2 Fransgård Maskinfabrik A/S Fredbjerg DK - 9640 Farsø Phone: +45 98 63 21 22 www.fransgard.dk mail@fransgard.dk...
- Page 3 LIST OF CONTENTS Page Technical Specifications ..............1 Safety Precautions ................ 2 Assembling instruction ..............2 Working position ................3 Overload release ................3 Transport position ................. 3 Ordering spare parts ..............4 Lubrication and Maintenance ............4 TECHNICAL SPECIFICATIONS Working width ..............
- Page 4 SAFETY PRECAUTIONS All screens must be correctly positioned and checked before starting the machine. Take care for stone fling. It is not advisable to remain in the working area of the machine while working parts are rotating. The machine is made to work in grass and strawcrops, and must not be used for anything else.
- Page 5 OVERLOAD RELEASE. The overload release near the three point lift is a safety guard which allow the cutterbar swing backward if it hit's into the ground, when it happen then stop the PTO. and drive backward and the overload release are going to lock again. TRANSPORT POSITION Change-over from working position to transport position is as follows:...
- Page 6 The cutterbar is filled with 2,7 litres of SAE 80/90 W gearoil. It should be checked daily and topped up if necessary. Change oil after approx. 10 hours of use, and then every 100 hours at least once a year. DM-2050...
- Page 7 Mounting of Disc with hat. Remove the nut, small disc and protection bushing from the shaft. Mount the Disc with hat, as shown on the picture, with the small disc and nut. Mount the plastic cover on the top. (You shall not use the protection bushing)
Need help?
Do you have a question about the DM-2050 and is the answer not in the manual?
Questions and answers