en Installation and connection
Siphon
Sink
Plastic pipe with
rubber sleeve or
gully
4.7 Aligning the appliance
In order to reduce noise and vibra-
tion and to prevent the appliance
from moving, align the appliance cor-
rectly.
Loosen the lock nuts using a WAF
1.
17 wrench by turning it in a clock-
wise direction.
16
Secure the con-
nection point with
a (24–40 mm)
hose clamp.
Fix and secure
the water outlet
hose with an el-
bow
→ Page 30.
Fix and secure
the water outlet
hose with an el-
bow
→ Page 30.
To align the appliance, turn the ap-
2.
pliance feet. Check that the appli-
ance is level using a spirit level.
All appliance feet must stand firmly
on the ground.
Screw the lock nuts tightly against
3.
the housing using a WAF 17
wrench.
In doing so, hold the foot tight and
do not adjust its height.
4.8 Connecting the appliance
to the electricity supply
Note: Your electrical domestic install-
ation for this appliance must comply
with the local legal provisions and
safety regulations, and should in-
clude a residual current circuit-
breaker.
Insert the mains plug of the appli-
1.
ance's power cable in a socket
nearby.