Installation - Electrolux EHS6940HOW User Manual

10 www.electrolux.com

8. INSTALLATION

WARNING!
Refer to Safety chapters.
8.1 Before the installation
Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Model .......................................
PNC .........................................
Serial number ...........................
8.2 Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
standards.
8.3 Connection cable
• For a single phase or two phase
connection use the following (or
higher) mains cable type: H05V2V2-F
T min 90°C.
• To replace the damaged mains cable
use the following (or higher) mains
cable type: H05V2V2-F T min 90°C.
Speak to your local Service Centre.
8.4 Building In
min.
55 mm
480 mm
min.
min.
650 mm
100 mm
30 mm
560 mm
A. supplied seal
B. supplied brackets
CAUTION!
Install the appliance only on
a worktop with flat surface.
8.5 Possibilities for insertion
The panel installed below the hob must
be easy to remove and let an easy
access in case a technical assistance
intervention is necessary.
Kitchen unit with door
A
60 mm
B
A. Removable panel
B. Space for connections
Kitchen unit with oven
The electrical connection of the hob and
the oven must be installed separately for
safety reasons and to let easy remove
oven from the unit.
A
B
30 mm
min 20 mm
(max 150 mm)