2.5
Hardware Installation
This section details the steps needed to install various hardware components for the
GENESYSM-TGU6. It is recommended that you read through each step before
beginning installation and to make sure you have all necessary tools and components.
2.5.1
Accessing the Bottom Panel
For this process you will need a Phillips head screwdriver.
Step 1: Remove the two black screws securing the bottom panel.
Step 2: The bottom panel will lift up and swing toward the rear panel of the system,
then can be removed.
Note: Be careful when opening if you have previously installed a 2.5" SATA Drive.
Chapter 2 – Hardware Information
37