Kodak EasyShare 5300 User Manual page 129

Message
Load plain paper for duplexing.
Message
Printhead missing or not
installed correctly.
Printer requires calibration.
Calibration unsuccessful
Cannot read calibration sheet.
Some photos may not be visible.
Maximum number of photos
exceeded.
Ink overflow container is full.
Printer error. Print job
unsuccessful.
There was an error reading the
tagged pictures on your input
device.
Message
Replace the rear access door.
Print job stopped.
Replace rear access door.
Press OK to restart job.
User's Guide
Paper Messages
Cause
the Proofsheet it must match the
current session number.
Wrong paper type for duplexing
loaded.
Print Messages
Cause
The printer has detected that a
Printhead is not installed.
The printer has detected that you
have installed a new Printhead
and now it must be calibrated.
Calibration sheet not inserted
correctly.
The printer detected a calibration
sheet, but can not read it.
A device was attached that
contained more than the
supported maximum of 1000
images. Memory Card or PTP
Camera, USB Thumbdrive.
The printer failed to finish
printing a swath successfully.
There is a DPOF file on the card
which the user has requested to
be used but the file is unusable.
Cannot read the file, formatting
of the data is not readable, file
could be corrupt.
Rear Access Door Messages
Cause
The Rear Access Door on the
back of the printer is off or not
properly installed.
During printing the printer
detected that the Rear Access
Door is latched.
Action/Solution
Load plain paper in the main
tray.
Action/Solution
Install the printhead.
Press Start to continue.
Check calibration sheet
placement and press OK to
continue.
Press the OK button on the
printer.
None.
Press the OK button to continue.
Press the OK button on the
printer.
None.
Action/Solution
Install the Rear Access door.
Latch the Rear Access door.
Support
125