Husqvarna TS138 Operator's Manual page 12

3. Connect the wire connector to the safety switch
(A) on the seat.
C
D
B
4. Put the seat on the seat pan (B) and put the
middle plastic piece (C) into the middle slot
assembly hole (D).
5. Push the seat rearward until the 2 front plastic
pieces (E) are aligned with the front slot
assembly holes. Push down the seat to engage
the plastic pieces in the slots. Push the seat
rearward.
2
6. Fold the seat forward and install the 2 bolts (F)
and the 2 washers (G).
F G
Note:
Make sure that the 2 front plastic pieces
(H) are fully engaged in the seat pan.
12
7. Remove the tape from the adjustment lever (I)
8. Do a check of the operator presence control.
E
A
To install the engine cover piece
1. Align the front tab on the engine cover piece with
2. Align the rear tabs on the engine cover piece
1
3. Push down the engine cover piece on the engine
H
I
To adjust the seat
1. Sit in the seat.
Note:
Make sure that the arrows on the 2
washers point up.
and discard the tape.
To do a check of the operator presence
Refer to
control (OPC) on page 7 .
WARNING:
product if the operator presence
control is defective.
the cut-out in the engine cover.
with the cut-outs in the engine cover.
cover.
Do no operate the
1966 - 001 -