Husqvarna TS138 Operator's Manual page 11

Steering shaft cover, 1 pcs
Hex bolt for the steering wheel, 1 pcs
Steering wheel adapter, 1 pcs
Steering shaft extension, 1 pcs
Top steering bracket, 1 pcs
Screws for top steering bracket, 4 pcs
Flat washer for steering wheel, 1 pcs
Lock washer for steering wheel, 1 pcs
Seat, 1 pcs
Hex bolt for the seat, 2 pcs
Flat washer for seat, 2 pcs
1966 - 001 -
To install the steering wheel
1. Install the steering shaft extension (A) on the
steering shaft (B).
K
J
I
H
G
2. Put the top steering bracket (C) onto the
steering shaft extension until it is flat against the
dashboard.
3. Install the 4 screws (D) with a screwdriver but do
not tighten the screws in this step.
4. Tighten the 4 screws with your hand until they
are flat against the top steering bracket.
5. Use a screwdriver to tighten the screws 90°
more.
CAUTION:
screws too much.
6. Install the shaft cover (E). Make sure that the
guide tabs in the shaft cover are in the correct
positions.
7. Remove the steering wheel adapter (F) from the
steering wheel (G).
8. Put the steering wheel adapter on the steering
shaft extension.
9. Put the steering wheel on the steering shaft
extension.
10. Make sure that the front wheels and the steering
wheel are aligned forward.
11. Install the large flat washer (H), the lock washer
(I), and the bolt (J). Tighten the bolt fully.
12. Attach the center cover (K) to the steering wheel.
The center cover is attached with snap locks.
To install the seat
1. Remove, but do not discard, the hardware which
attaches the seat to the cardboard package.
2. Remove and discard the cardboard package.
Note:
Do not remove the tape from the
adjustment handle until the seat is correctly
attached to the product.
F
A
C
D
E
B
Do not tighten the
11