Advertisement
Installation
STEP 1
Using a stud finder or other accurate
method, locate center point between two
joists and mark. Using template provided,
trace hold pattern on surface of ceiling.
STEP 2
Using a sabre saw, keyhole saw or very
sharp utility knife, cut hole in ceiling.
Following trace pattern.
STEP 3
Run loudspeaker wire to sound source
location. There are several methods you can
use to accomplish wiring, depending on the
construction characteristics of the room or
house. You can add a professional touch to
your installation by using a speaker terminal
plate at the source location. Leave enough
Hall Technologies
July 15, 2022
wire at speaker. Location (8-10 inches / 20-
25 cm) to complete connection.
STEP 4
Attach
loudspeaker
terminals, observing correct polarity and
position speaker frame up into cutout. Be
careful not to pinch wires in the process.
STEP 5
Carefully tighten the four mounting screws.
This will cause the mounting wings to rotate
wires
to
speaker
Page 6 of 10
Advertisement
