Advertisement
Figure 3
1. Bumper
6.
Slide a frame spacer onto each end of the roller
(Figure
4).
Figure 4
1. Roller
2. Frame spacer
3. Pull frame
4. Flat washer
5. Pull link spacer
7.
Secure the roller to the pull frame as shown in
Figure
4.
8.
Thread a jam nut and the previously removed
ball joint receiver onto the pull link assembly
2. Self tapping screw
6. Pull link assembly
7. Flange bushing
8. Grease screw
9. Jam nut
10. Ball joint receiver
(Figure
4). Do not tighten the jam nut at this
time.
9.
Adjust the ball joint receiver so that the distance
between the grease screw and the opening in
the ball joint receiver is 9.1 cm (3.6 inches) and
tighten the jam nut to secure it in place
5).
g245920
1. 9.1 cm (3.6 inches)
10.
Thread a ball stud onto each end of the groomer
front rollers
g245921
11.
Slide the sleeve on the ball joint receivers back
and hook them onto the groomer ball studs.
2
Figure 5
(Figure
6).
Figure 6
(Figure
g245942
g245963
Advertisement
