Advertisement

Quick Links

OWNER'S MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Traditional Clean and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Two-Rock Traditional Clean

  • Page 1 OWNER'S MANUAL...
  • Page 2: Dear Customer

    Dear Customer, Thank you for your purchase of a Two-Rock amplifier! As a discerning guitarist, you know the road to great tone begins with great components. Our Classic Design, carefully selected parts and hand-built approach combine to make an extremely versatile instrument.
  • Page 3: Front Panel Functions

    Front Panel Functions INPUT JACK - High impedance input to the amplifier. Plug in your instrument here. BRIGHT Switch - Boosts the high frequency response. This is most effective when the Gain control is set at 12 o’clock or lower. This is great for adding sparkle to clean tones. The effect is less dramatic as the Gain control is adjusted past the 12 o’clock position.
  • Page 4 MASTER - Adjusts the overall output level of the amplifier. At lower settings on this control the amp will be much cleaner sounding as well as lower in volume. As this control is turned up the power section of the amp begins to work harder which increases sustain, fullness, and touch dynamics as well as raising the volume of the amplifier.
  • Page 5: Rear Panel Functions

    Effects Loop – The effects loop on this amplifier is a passive type of loop, see FAQ on two-rock.com Send - Use this jack to send the amplifier’s signal to the effects that you want to use in the loop.
  • Page 6: Fuse Chart

    Fuse Chart All Fuses are 3AG Type 250 Volt, SLO-BLO Export 100 Volt Domestic Fuses: Export 220, 230, 240 Fuses: 3.5 - 100 Watt 4x6L6 3.25 - 100 Watt 4x6L6 1.6 - 100 Watt 4x6L6 2.8 - 50 Watt 2x6L6 2.5 - 50 Watt 2x6L6 1.25 - 50 Watt 2x6L6 TUBE COMPLIMENT...
  • Page 7 IMPORTANT: BIAS NOTE FOR AMPLIFIERS! These amps are biased differently than some other models. Please check proper bias settings for your wattage. BIAS PROCEDURE: • Make sure the speaker is connected properly, then power up the amplifier. • Set the rear panel power mode switch to Full or Hi •...
  • Page 8 Please contact us with any other questions or comments that you may have. We look forward to hearing from you! PHONE: 1(707)584-TONE (8663) (M-F 9am-5pm PST) ADDRESS: Two-Rock Amplifiers, LLC 619 Martin Avenue, Suite 5 Rohnert Park, CA 94928 CONTACT: info@two-rock.com WEB: www.two-rock.com...
  • Page 9 619 MARTIN AVENUE, SUITE 5 ROHNERT PARK, CA 94928 707-584-8663 www.two-rock.com SERIAL NUMBER:...

Table of Contents