Advertisement
Perform a measurement
•
Turn on the device by pressing "On/Off/Esc".
Put the probe(s) to the required location.
The device displays the temperature measurement with the thermocouple type indicated below.
If the thermometer used is the TK62 with two connected probes, the device displays the two measurements.
•
Press "OK" to display the delta T between the two measured temperatures.
Hold the measurement, display the maximum and minimum
During a measurement:
•
Press "Hold/min/max".
"Hold" is displayed and the measurement is frozen.
•
Press again "Hold/min/max".
The device displays the maximum value measured since the last questioning of the frozen channel at the top of the
screen and the minimum value measured since the last questioning of the frozen channel at the bottom of the screen.
For a TK 62 with two connected probes:
The device displays the maximum value of the T1 probe measured since the last questioning of the frozen channel at
the top of the screen and the minimum value of the T1 probe measured since the last questioning of the frozen channel
at the bottom of the screen.
•
Press again "Hold/min/max".
The device displays the maximum value of the T2 probe measured since the last questioning of the frozen channel at
the top of the screen and the minimum value of the T2 probe measured since the last questioning of the frozen channel
at the bottom of the screen.
•
Press again Hold/min/max.
The device displays the maximum value of the delta T since the last questioning of the frozen channel at the top of the
screen and the minimum value of the delta T since the last questioning of the frozen channel at the bottom of the screen.
•
Press "On/Off/Esc" to return to the measurement display.
Set the device
Select the thermocouple type
The device is on and displays the measurement.
•
Press "Selection".
"PROBE" blinks on screen.
•
Press "OK".
The thermocouple type currently used blinks on screen.
•
Press "Selection" until the required thermocouple type appears: K, T, J or S. Press "OK" to confirm the selection.
"PROBE" blinks on screen.
•
Press "On/Off/Esc" to return to the measurement display.
Select the temperature unit
The device is on and displays the measurement.
•
Press "Selection" until "UNIT" blinks on screen. Press "OK".
The unit currently used blinks on screen.
•
Press "Selection" until the required unit appears: °C or °F.
•
Press "OK" to confirm the unit selection.
"UNIT" blinks on screen.
•
Press "On/Off/Esc" to return to the measurement display.
Set the auto shut-off
The device is on and displays the measurement.
•
Press "Selection" until "AUTO OFF" blinks on screen. Press "OK".
The time before the device auto shut-off blinks at the bottom of the screen.
•
Press "Selection" until the required time before the device auto shut-off appears: 15, 30, 45, 60, 75, 90, 105, 120
minutes or OFF.
•
Press "OK" to confirm the selection.
"AUTO OFF" blinks on screen.
•
Press "On/Off/Esc" to return to the measurement display.
Advertisement
