Texas Instruments SimpleLink CC3 20 Series User Manual page 9

Wi-fi radio tool
Hide thumbs Also See for SimpleLink CC3 20 Series:
Table of Contents

Advertisement

www.ti.com
Table 7-2
lists parameter explanations.
Parameter
Range (inclusive)
Channel
[1, 13]
[36..165]
Power level
[0 to 15]
Tone
[-25, 25]
Rate
Preamble
[Long, Short]
Data pattern
Size
[24, 1400]
Delay
[100 to 1,000,000]
Amount
[0 to 1,000,000]
Override CCA
CCA threshold
Destination MAC address
Country
Figure 7-2
shows the RadioTool GUI in the TX Tab.
SWRU471B – FEBRUARY 2017 – REVISED AUGUST 2020
Submit Document Feedback
Table 7-2. Parameter Explanation
Description
802.11 2.4-GHz band Wi-Fi channels. 14 is not supported.
5-Ghz channels are enabled only for devices: CC3235x, CC3135
0 is the maximum power, and 15 is the minimum power.
For 5-Ghz channels this parameter has no affect and the actual output power will
be set to 0.
CW only. 0 is tone at center frequency. A value N between and within the range [–
25, 25] means tone at offset N*312.5 kHz.
802.11 PHY data rate. 5Ghz channels has no support for DSSS and CCK rates.
Supported:
DSSS: 1 Mbps, 2 Mbps
CCK: 5.5 Mbps, 11 Mbps
OFDM: 6/9/12/18/24/36/48/54 Mbps
MCS 0-7
802.11b preamble.
OFDM preamble is automatically configured by the device when OFDM rates are
selected.
Data pattern in the data field. Supported:
All 0: 0x00, 0x00, 0x00...
All 1: 0xFF, 0xFF, 0xFF...
Incremental
Decremental
Packet size in bytes
Delay of transmission in milliseconds (ms)
Number of packets to transmit. A value of 0 indicates infinite number of packets.
Enable this field for CCA (Clear Channel Assessment) override if the Wi-Fi
environment is too congested to have a reliable periodic transmission.
The channel is considered occupied when the signal strength is above this setting.
Supported:
–88 dBm (MIN)
–78 dBm (LOW)
–68 dBm (DEFAULT)
–58 dBm (MED)
–48 dBm (HIGH)
–38 dBm (MAX)
Destination MAC address in packets
Sets device country code. Supported: US, EU, JP. For devices CC3135 and
CC3235x there are additional country codes options. There is an option to select
"No Limits" to remove all channel limitations or "00" for minimal limits.
Copyright © 2020 Texas Instruments Incorporated
SimpleLink™ Wi-Fi® CC3x20, CC3x3x Radio Tool User Guide
Running the RadioTool GUI
9

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SimpleLink CC3 20 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Simplelink cc3 3 series

Table of Contents