Fort ECSPHB Quick Start Manual

General
Our products are designed to comply with the recommended
codes and practice, and is to be installed and serviced by
competent persons in accordance with the relevant
regulations.

Contents

The Smart hub is supplied separately and as part of a
kit, please check the packaging to ensure all required
accessories are included.
The Smart hub is supplied with a power adapter, the
accessories with the required batteries and screw
pack.

Installation

For best performance the final installation site of the
hub will be at the central point of the system.
Connect the supplied power adapter to the hub and
apply power, the hub will operate after 60secs.
Connection button
Power adapter input
Power switch

HUB LED Indications

Red Flashing/Fixed: System Armed
Blue Flashing/fixed: System armed in home mode
Green Flashing/fixed: System disarmed
Red/Blue/Green fixed: Connected to the server
Red/Blue/Green Blink Slowly: Wi-Fi network disconnected
Green Blink Fast: Wi-Fi network settings EZ mode
Blue Blink Fast: Wi-Fi network settings AP mode
White fixed: RF connection mode
Elite Security Products
Redditch B98 8YN
Smart Security Hub
ECSPHB
USB Interface
SIM card slot
(Full size)

Preparation For Use

Ensure that the smart phone is connected to the same Wi-Fi
network that you would like to attach the device.
Ensure that you have a mobile device running iOS 8 or higher
or Android 4.1x or higher and a 2.4GHzWi-Fi connection.
Sign in or Register following the
instructions on the ClickSmart+ App.

Adding Accessories

If the hub has been supplied as part of a kit the accessories will
be pre-paired for convience. For additional accessories;
PIR
1. Select your ESP Hub in the ClickSmart+ app, click on
"Accessories" along the bottom, then click on "Detectors"
at the top, then click on "+ Add", finally press the test button
on the back of the PIR.
2. The control panel will beep once to acknowledge the
connection, or twice if this PIR has already been paired.
Door/Window Contact
1. Select your ESP Hub in the ClickSmart+ app, click on
"Accessories" along the bottom, then click on "Detectors"
at the top, then click on "+ Add", finally seperate the magnet
from the transmitter.
2. The control panel will beep once to acknowledge the
connection, or twice if this Door Contact has already been
paired.
Remote Control
1. Press once on the "Connection Button" on the your ESP Hub
2. Press "Arm" on the Remote control
3. The control panel will beep once to acknowledge the connec-
tion, or twice if this Remote Control has already been paired.
Siren
1. Press the "Connection Button" on your siren for one second.
The LEDs should illuminate, the siren is now in connection mode
for 20 seconds.
2. Press "ARM" or SOS" on your control panel (not VIA a remote
control). you should hear one beep; the siren is now connected.
Products bearing this mark
are compatible with the Clicksmart+ APP