Mitsubishi 4DQ3 Service Manual page 28

(b) Tighten connecting rod clamping nuts to a torque of
5.5 kgm (39.771 lb.ft).
(7) Install the retainers and gaskets as follows:
(a) Install retainers (1) to the external peripheries
of main bearing caps No. 1 and No. 3 with the
flange facing the case inside.
(b) Apply ThreeBond 1102 (adhesive) on both sides
of oil pan gasket (2) and attach it to crankcase.
Make sure that the gasket is completely attached
in the grooves (A) in the caps.
(c) Apply Atomjet on the both ends of rubber
packing (3) and insert the packing into cap.