Display - Dell OptiPlex 7400 All-in-One Setup And Specifications

Table 18. Power supply connector (continued)
220 W (80 PLUS Platinum)

Display

The following table lists the display specifications of your OptiPlex 7400 All-in-One.
Table 19. Display specifications
Description
Display type
Display-panel technology
Display-panel dimensions (active area):
Height
Width
Diagonal
Display-panel native resolution
Luminance
Megapixels
Color gamut
Pixels Per Inch (PPI)
Contrast ratio
Response time
Refresh rate
Horizontal view angle
Vertical view angle
Pixel pitch
Power consumption (maximum)
Anti-glare vs glossy finish
Adaptive sync
Stylus support
28 Specifications of OptiPlex 7400 All-in-One
● One 2 pin connector for LED
● One 16 pin connector for system board
● One 2 pin connector for LED
Option one (non-touch display)
Full High Definition (FHD), Low Blue
Light
Wide Viewing Angle (WVA)
296.46 mm (11.67 in.)
527.04 mm (20.75 in.)
604.70 mm (23.81 in.)
1920 x 1080
● 250 Nits (typical)
● 200 Nits (minimum)
2.07
99% sRGB (typical)
92
● 700:1 (minimum)
● 1000:1 (typical)
● 25 ms (maximum)
● 14 ms (typical)
60 Hz
● 170 degrees (minimum)
● 178 degrees (typical)
● 170 degrees (minimum)
● 178 degrees (typical)
0.2745 x 0.2745 mm
12.70 W
Anti-glare
Not applicable
Not applicable
Option two (touch-display)
Full High Definition (FHD)
Wide Viewing Angle (WVA)
296.46 mm (11.67 in.)
527.04 mm (20.75 in.)
604.70 mm (23.81 in.)
1920 x 1080
● 250 Nits (typical)
● 200 Nits (minimum)
2.07
72% NTSC typical
92
● 700:1 (minimum)
● 1000:1 (typical)
● 25 ms (maximum)
● 14 ms (typical)
60 Hz
● 170 degrees (minimum)
● 178 degrees (typical)
● 170 degrees (minimum)
● 178 degrees (typical)
0.2745 x 0.2745 mm
13.48 W
Anti-glare
Not applicable
Capacitive touch