INSTALLATION
N24/N32/N40
Troubleshooting
If Printer does not Start
Make sure the power cord is attached to the printer
Check to see that the power cord is plugged into a wall
socket
Make sure the controller board is installed properly
If the Printer does not Return a Status Sheet
Check to see that the controller board is installed
properly
Make sure the printer has a toner cartridge installed
Make sure the X/TRA XLi parallel interface is connected
to the Centronics parallel port on the printer.
Check to see that the X/TRA XLi is securely connected
to the controller board
figure 2.7
Page 2-21
N17