Table of Contents
Advertisement
Follow below steps to configure S100 to receive correction data via USB interface. The app closes when
the S100 starts to work as USB RTK rover.
1. Make sure S100 is connecting with PC via USB interface.
2. Switch to Rover tab in app. See Figure 4-7 a
3. Click Start of "USB Input Rover"; the Polaris Connect app will close. See Figure 4-7 b
4. Start third-party tool, e.g. strsvr of RTKLIB, to receive RTK correction data, sends it to S100, and
receive position data stream from S100. See Figure 4-7 c.
5. COM port splitter program will be needed to enable another program to share the same COM port
to use the NMEA output.
a
Figure 4-7
b
c
15
Advertisement
Table of Contents
