scigiene PT0572 Quick Start Manual

FOR THIN CUTS OF MEAT AND
GENERAL PURPOSE COOKING
•
Accuracy: ±0.4°C/±0.7°F
•
NSF® Certified
•
4 second response
•
1.5 mm thin tip
•
3.5"/8.9 cm, 304 stainless steel stem
•
Waterproof (IPX7: protected from water up to 3
feet/1 meter for 30 minutes)
•
Field calibration
•
High heat
•
Max/min
•
Data-hold
•
Big digit
•
180° rotating display
•
On/off button
•
Auto-off after 10 minutes
•
Food-safe ABS plastic with BioCote®
•
Temperature guide on thermometer
•
2-way mounting: pocket clip/hook
•
Two 1.5V IEC LR44 button alkaline batteries
(included)
Note: Remove label from display before initial use. Clean the
thermometer stem before each use.
PT0572 WATERPROOF THIN TIP
Note: In the following instructions, names of the control buttons
are shown in CAPS. Function information that appears on the
display is shown in BOLD CAPS.

BATTERY INSTALLATION

Replace batteries when LCD becomes dim. "---" flashes
on the display when the batteries need to be replaced.
1. Power off the unit before installing the batteries.
A malfunction may occur if the power is on when
the batteries are installed. If a malfunction
occurs, restart the device.
2. Using a small Phillips screwdriver, remove the
screw on the back by the pocket clip by turning it
counterclockwise.
Note: Be careful to use a properly sized screwdriver as a
screwdriver too large will strip the screwtops.
3. Remove the cover completely.
4. Install two LR44 batteries with positive (+) sides
up.
5. Replace the battery cover.
Important: THE WATER RESISTANT FEATURE REQUIRES
MAINTAINING THE RUBBER GASKET EVENLY WITHIN THE
GROOVE.
6. Fasten the screw on the back by turning it
clockwise, being careful not to over-turn.

OPERATING INSTRUCTIONS

A. On/Off

1. Press the POWER button ( ) to turn the
thermometer on.
2. The PT0572 will automatically turn off after 10
minutes of inactivity.
3. Press the POWER button ( ) again to turn the
thermometer off and conserve battery life.

B. Temperature Scale

To select temperature reading in Fahrenheit or Celsius:
1. Using a paperclip, press the °F/°C button on the
back to change the scale.
2. The °F or °C symbol changes on the display.

C. Display Rotation

While the PT0572 is on, press and hold the MAX/MIN
button to rotate the display orientation 180 degrees.
Note: Pressing and holding the MAX/MIN button in the Max or Min
mode will clear the values.
Model: PT0572
THERMOMETER
-40 to +572°F/-40 to +300°C