Advertisement
6
7
G016963
1. Hydraulic oil tank
2. Fan mount
3. Radiator
4. Hex-head screw (1/4 inch)
5. Double R-clamp
6. Clip
7. Hydraulic oil manifold block
8. Insert the adapter fitting here.
9. Adapter fitting
10. Hose clamp
6. Remove the 2 knockouts in the sealing plate for the
oil cooler wiring and the hydraulic hoses to pass
through.
7. Install a rubber grommet in the largest knockout
hole (Figure 2).
8. Install the double R-clamp to the fan mount with a
hex-head screw (1/4 x 5/8 inch) and a clip as shown
in Figure 2.
9. Install 5 clips to the radiator as shown in Figure 2.
3
4
5
8
12
11
9
10
11. Hydraulic hose end and fitting (attached) 21. Cooler cover
12. Bushing
13. 90-degree elbow fitting
14. Cooler hose
15. Sealing grommet
16. Cable ties
17. Knockout for wiring
18. Sealing plate
19. Temperature sender
20. Cooler housing
2
13
6
10
14 15
17
19
18
Figure 2
10. Install the temperature sender to the oil cooler
(Figure 2).
11. Route the hydraulic hose from the oil cooler through
the sealing plate to the hydraulic oil manifold block
as shown in Figure 2.
Note: Do not connect the hose ends yet.
12. Route the cooler hose from the oil cooler through
the sealing plate to the hydraulic oil tank as shown
in Figure 2.
Note: Do not connect the hose ends yet.
3
1
4
20
16
22
10
23
4
27
28
22. Flange nut (3/8 inch)
23. Upper cooler bracket (2)
24. Cooler tab (2)
25. Shoulder bolt (2)
26. Spring washer
27. Lower cooler bracket (2)
28. Oil cooler
21
10
24
25
26
4
Advertisement
