Table of Contents
Advertisement
1)Assembly
a. Assembly of the dust bag
Before using the tool, you should install the dust bag to the tool. Use only a dust bag. Any
other container is not compatible with this tool.
Wear a protective mask. Harmful and toxic dust may be produced when using the sander.
This dust can interfere dangerously with your and others health. Kindly always wear a
protection mask against dust when using this product. Keep people and animals away from
the work area when the device is running.
b. Assembly of the suction flexible hose to the dust ejection hole of the sander
-
Open the sander coupler by turning the large nut counter clockwise;
-
Push the swivel adaptor at the end of the flexible hose into the coupler of the sander;
-
Turn the large nut clockwise to tighten the connection of the two adapters.
-
To avoid tangling the suction flexible hose and power cable, we advise attaching them
spaced apart by a few Velcro straps.
c. Assembly and changing of the abrasive discs
-
Turn off and unplug the tool from the power supply.
-
Turn the disc holder fixing nut counter clockwise and remove the nut.
-
Avoid the metal washer and abrasive disc.
-
Place on a new abrasive disc. Block the sanding plate and then repeat the previous steps
in reverse order.
Make sure that the disk and fixing but are properly installed.
-
1) Use
a. Switching on and off of the sander
Make sure that your electrical supply corresponds to that indicated on the nameplate of the
sander.
The sander must be turned off (on OFF switch) before connecting it.
Connect the power cable to the power supply
To start the tool, turn the switch to the ON position. To stop the sander, turn the sander OFF.
b. Speed adjustment
This sander is equipped with a variable speed drive allowing the user to choose the desired
rotation speed. The speed can be adjusted by turning the rotary knob on the speed controller,
having 7 positions (min to max). Level min is the slower speed (approximately 1500 rpm)
while level max is the higher (approximately 3200 rpm). A higher speed should be used for
equalization and removal. A slower speed may be used for precise refinement.
10
Advertisement
Table of Contents
