ACME Taurus MAI 2 Quick User Manual

ACME Taurus MAI 2 Quick User Manual

Pump & mixer

Advertisement

Taurus Quick User Guide
MAI 2Pump Taurus & Mixer Quick User Guide

Preparation

1. Pour water into the hopper.
2. Connect hose to the coupling.
3. Turn on the machine and wait for the water to be pumped out of the hose. (Pay
attention to the water level in the hopper. Ensure that it does not fall below the
minimum material level, which covers the entire screw)
4. Stop the machine once the water comes out of the hose.

Mixer

1. Start the mixer.
(DO NOT load the material when the mixer is off, otherwise the mixer will not start)
2. Once the paddle started moving, add in the dry material.
3. Add water into the dry mix.

Pumping

1. When the material is fully mixed, start to pour by opening the outlet.
2. Start the pump and allow the material to push the remaining water out of the hose.
3. When the material starts to come out of the hose, you can start your work. (ALWAYS
keep the material above the minimum material level. DO NOT dry run the pump,
there must be at least water that is in the pump)
Pg 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Taurus MAI 2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ACME Taurus MAI 2

  • Page 1 Taurus Quick User Guide MAI 2Pump Taurus & Mixer Quick User Guide Preparation 1. Pour water into the hopper. 2. Connect hose to the coupling. 3. Turn on the machine and wait for the water to be pumped out of the hose. (Pay attention to the water level in the hopper.
  • Page 2 Taurus Quick User Guide Stopping & Cleaning 1. Stop the pump when the job is finished. (You can pump out the remaining material until the minimum material level) 2. Use water to clean the pump’s hopper. 3. Disconnect the hose from the coupling, insert a wet sponge ball into the hose. (DO NOT disconnect the hose if there is any pressure shown in the pressure gauge, use the reverse function to reduce the pressure to 0 before any further cleaning work can be made)

Table of Contents