Stereoping Synth Controller Owner's Handbook Manual page 3

1.
Features, power supply, editions
The Stereoping Synth Controller offers 16 knobs and 3 buttons to quickly tweak the sound of your favourite
vintage music synthesizer in a comfortable way. Right at the moment you dial a knob, it sends the appropriate
message in Midi SysEx-format over the Midicable into your synth, changing it's sound immediately.
Features
Synthesizer hardware realtime editor
•
Frontpanel designed to match the target synthesizer's design
•
Easy operation, avoiding cryptic 'Shift' or 'Alt' operations
•
Beautiful lighted colored buttons of durable quality
•
Tough and handsome steelcase
•
Protection diode to avoid damage from PSUs with wrong polarity
•
Built in 'Midi Control Change to SysEx'-translator for changing and automating your synths parameters
•
with standard Midi Control Change messages
Handy 'move pot without sending messages'-feature to prevent excessive parameter jumps
•
Useful 'Bypass Mode' letting all Mididata pass unfiltered for smallest latency and ignoring pot changes
•
Learnt Midichannel keeps stored in memory
•
Firmwareupdate via SysEx-dump
•
Hardware compatible throughout all editions
•
Current draw 40 mA
•
Weight without power supply 660g
•
Size incl. Knobs and rubber feet about 180 x 130 x 60 mm
•
Technical handling
The Synth Controller was built to be used in a comfortable music studio environement. You can operate it under
free skies of course. But please keep in mind, it uses electricity for proper operation and therefore is quite
sensitive to water, drinks or other fluids. Excessive heat or exposition to sunlight is also not advised.