Kenwood PWR 18-2 Instruction Manual page 10

Unlike in M A S T E R operation, machines of different types
can be connected. However, the maximum number of
machines connected should be limited to four.
© Set the A D D R E S S NO.'s of the S L A V E units.
Set the A D D R E S S N O . ' s of the slave units in the same w a y
as for M A S T E R operation.
Each of the A D D R E S S NO.'s should be set to a value from
" 1 " to "26". Remember that operation failure will result
if more than t w o machines have the same A D D R E S S
NO., or if any of the A D D R E S S N O . ' s is set to " 0 " .
® Connect the PWR power supply to the PC or other terminal
device (MASTER unit).
R S - 2 3 2 C
Terminal Device
(Computer etc.)
10
1) Connect the remote controller (PWR1 remote connector IN)
with the master unit, using the connecting cord which comes
included with the PWR series power supply unit.
Use the optional modular/D-SUB conversion connector (TA-60)
for the R S - 2 3 2 C connector on the master unit.
Refer to the diagram shown below for the connection between
the R S - 2 3 2 C connector and PWR1 remote connector IN.
Connection diagram of TA-60
Terminal Device
R S 2 3 2 - C connector
© M A S T E R unit frame
GND
© B A
© B B
© M A S T E R unit signal
GND
© C A
© C C
® C F
© C B
© C D
When connecting the M A S T E R unit to the P W R , be sure
that the POWER switches of both units are set to " O F F " .
PWR
REMOTE IN connector
© P W R frame GND
© R X D
© T X D
© P W R signal GND
© NC
© NC