Advertisement
Quick Links
Advertisement
Related Manuals for Equalizer RAPTOR F22
Summary of Contents for Equalizer RAPTOR F22
- Page 1 ™ User Guide Part Numbers: F22 • F22KIT...
-
Page 2: Warranty Information
Warranty does not apply to abuse, misuse, normal wear and tear, or to accessories or damage caused where repairs have been made or attempted by unauthorized persons. Using wire and/or cord other than the authorized and recommended Equalizer wire and/or cord will ®... -
Page 3: Preventative Maintenance
There may be times when you have to position or adjust the tool for a specific application other than what this guide provides. For technical support and tips please contact us for assistance at 512-388-7715. To watch Instructional Videos go to equalizer.com/videos or scan the QR code below: Do not use with a power Using wire/cord other... - Page 4 Windshield Removal with Raptor ™ Vehicle Prep: • Remove wipers and cowling to give proper access to the bottom of the windshield • Remove the rearview mirror • Identify any clips or stops • Clean inside and outside of glass It is recommended to use the Snake Eyes boroscope unit (SE545) prior ™...
- Page 5 Tip: To determine the direction you need to wrap the wire/cord on the Raptor from inside the car looking ™ through the windshield determine which direction you want to cut. In this case we are working on the windshield cutting from passenger to driver side in a clockwise direction therefore wrap the wire/cord onto the Raptor counter clockwise.
- Page 6 Windshield Setting Pins: Be aware that most vehicles have setting pins installed from the factory (up in each corner) to allow the installer or robot to place the glass in the perfect spot during construction of the vehicle. There are two methods to cut behind the setting posts: 1.
- Page 7 Quarter Glass Removal With Raptor ™ Vehicle Prep: • Remove all trim panels surrounding the work area • Identify any clips/setting pins Clean the glass and place the Venom Wire Dispenser ™ (WDD167) on the outside of the quarter glass. Many vehicles will have an encapsulation around the quarter glass which will make it impossible to insert the wire starter from inside the vehicle (as many technicians...
- Page 8 To begin cutting, start the ratcheting action slowly and apply slight pressure, with one hand, on the dash protector against the glass where the wire/cord is coming through. Reposition the Raptor as needed to create the best cutting angle. ™ Repositioning is simple with the Raptor .
- Page 9 Back Glass Removal With Raptor ™ Vehicle Prep: • Remove interior trim and remove wiper assembly if applicable. • Remove exterior trim, spoilers, etc. if applicable in order to gain access to the glass. To get started, place the Venom Wire Dispenser ™...
- Page 10 PREVENTATIVE MAINTENANCE: • Hold the tool in the upright position to clean the cup with a new damp towel to remove any residue or debris from the cup and then dry with a clean towel. • Keep protective cup cover on the Raptor when not in use and ™...
- Page 12 ™ 2611 Oakmont Drive • Round Rock, TX 78665 800.334.1334 • 512.388.7715 • 512.388.4188 Fax sales@equalizer.com • www.equalizer.com Rev. 2/6/19b...
Need help?
Do you have a question about the RAPTOR F22 and is the answer not in the manual?
Questions and answers