Equalizer Transformer TFM1000 User Manual

@
Equalizer;

USEFUL TIPS

f) •
• Use proper vehicle protection during use.
Be sure both locks are secured before using the Equalizer
™
Transformer on the JVCl 92 Visual Vacuum Cup.
• Be mindful of the cord or wire crossing or twisting during setup. (see
instructional video)
• When using wire, be conscious of possible spring-back when wire
A
gets unspooled.
- •When using your drill of choice, we recommend a low speed setting
for a smooth cut. Using a higher speed may cause the cord to break or
wire to snap. *DO NOT USE IMPACT TOOLS WITH YOUR TRANSFORMER

TRANSFORM YOUR CUP

• Replace the 4-standard JVC192- Vacuum Cup screws with the
4-Transformer ® screws/studs provided.
• Add the Transformer
on the studs, aligning with the grooves on the tool, and lock into place
using the locking pins.

WINDSHIELD SET-UP AND REMOVAL

• Insert cord on the spindle on one side of the Transformer
cord half-way, using approximately 10 feet of RipCord'M. Un spool
another 10 feet of cord from RipCord'M spool, cut, then insert the
cut-end on the opposite spindle of the Transformer
instructional video for demonstration)
• Place the Transformer
the passenger side. Using the Wirestarter'M; insert the cord from the
Transformer ® into the urethane on the b ottom driver side corner. Lace
the cord on the outside perimeter of the windshield.
• Using either the ratchet (included) or your drill with provided drill bit,
begin cutting on preferred side of the Transformer
utilizing the b uilt-in anchor mechanism, keeping the desired cutting
angle until your cut-out is complete.
QUARTER GLASS REMOVAL WITH
™
SIDESTRIKER
• Insert cord on the spindle on one side of the Transformer
around perimeter of the quarter glass on the outside. Anchor using
Equalizer Large or Mini anchor cup (sold seperately) to the vehicle.
®
• Attach the SideStriker'M to the door striker, insert Transformer
SideStriker'M and secure with locking pin.
• Using either the ratchet (included) or your drill with provided drill bit,
begin cutting until your cut-out is complete.
sales@equalizer.com
® to your cup by sliding the two pieces together
® on the inside top corner of the windshield on
IRAnsFDRI
USER GUIDE

TFM1000 Includes:

Transformer
®
TSD192-

TFM192 Includes:

TFM1000, LC520-Dash Protector, JVC192-Visual Vacuum Cup ,
FSG130-Pistol Grip Wire Starter, FG1129-Safety Glasses ,
RC100-RipCordHD'", CU1077-Dash Protector, GSS220-Guide Sheets
®
® , wind the
® and wind. (see
® . Alternate sides
® , lace cord
to the
'M
www.equalizer.com
PRM338-Ratchet, 2688-Screw s/Studs (4),
® Tool,
SDS192-SideStriker'",
Drill Bit,
11Eg·
I-SDS-FP-Protection Pad
512-.388. 7715