Advertisement
Learn About Your Weego OBDII
12V Memory Saver!
When you remove or disconnect the battery
from your vehicle, the electronics lose their
saved settings. The Weego Memory Saver
allows you to change your battery without
losing or resetting anything!
12V/10A Connector
OBD II Connector
Before Getting Started
1. Read vehicle's owner's manual: The
vehicle manufacturer may have speci c
cautions and instructions about replacing
your vehicle battery. It will also show you
how to locate your vehicle's OBDII port.
2. Turn off all electronics in your vehicle (air
conditioner, heat, radio, lights, chargers,
etc) to prevent any damage to your Weego
Memory Saver.
3. Make sure your vehicle has been off for
at least 20 minutes before using your
Memory Saver – this is how long it takes for
your computer to fully shut down.
Ready, Get Set, Weego!
1. Connect your Memory
Saver cable into your
vehicle's OBDII port.
Red LED
Indicator Light
2. Connect the other end of the Memory
Saver cable into the 12V/10A port on your
Weego Jump Starter Battery+.
Model N66
3. Power ON your Weego.
You should see the Red LED
Indicator Light on your
Memory Saver illuminate,
indicating a good connection.
12V/10A
Output Port (Black Port)
Model N44
Red LED
Indicator Light
4. You may now disconnect the vehicle's
battery.
5. After the new battery is installed,
disconnect the Memory Saver from your
Weego, then disconnect the Memory Saver
from your vehicle.
Warnings
1. DO NOT start your vehicle while your
Weego is connected to your vehicle through
the Memory Saver.
2. Keep your Memory Saver clean and wipe
with a dry cloth after each use.
3.When you disconnect your vehicle's
battery, the battery connector cables are
still live, and will receive some power from
your Weego. Please take caution and do
not let them touch one another, or any
conductive material, during that time.
Visit myweego.com to learn more about
other Weego products and accessories.
Advertisement
