Dishwasher Features - KitchenAid KUDD03ST User Instructions

Drawer dishwasher
Hide thumbs Also See for KUDD03ST:
Table of Contents

Advertisement

Available languages

Available languages

OPTION SELECTIONS
OPTIONS
DISH LOAD TYPES
To run your dishwasher at
a later time or during off-
peak hours.
Control Lock
To avoid unintended use of
your dishwasher, or cycle
and option changes during
a cycle.
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat and water as needed.
CONTROLS AND
CYCLE STATUS
CONTROL
PURPOSE
To start or resume a
wash cycle
To cancel wash
cycle
To follow the
progress and status
of your dishwasher
cycle
SURE-HOLD
®
Small Items Mesh Pouch
This pouch hangs on the rack. Use
it to hold small items that could
otherwise "fly" around inside the
dishwasher during a cycle.
6
DESCRIPTIONS
Delays the start of a cycle up to 4 hours.
Select a wash cycle and options. Press 4 Hour Delay. Press
START/RESUME. Close the drawer firmly.
To turn on Lock, press and hold ProDry for at least
4 seconds.
To turn off Lock, press and hold ProDry for at least
4 seconds.
When Control Lock is lit, all buttons are disabled. If you press
any pad while your dishwasher is locked, the light flashes
3 times. The dishwasher drawer can be opened while the
controls are locked.
COMMENTS
If the drawer is opened during a cycle or the power is interrupted, the Start/Resume indicator
flashes. The cycle will not resume until the drawer is closed and Start/Resume is pressed.
Close the drawer firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely.
Clean indicator glows when a cycle is finished.
If you select the Sani Rinse option, when the Sani Rinse cycle is finished, the Sanitized indicator
glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the
cycle. This can happen if the cycle is interrupted, or the water could not be heated to the required
temperature. The light goes off when you open and close the drawer or press CANCEL.
Rinse aid low indicator light glows when the rinse aid dispenser needs to be refilled.

Dishwasher Features

Your KitchenAid dishwasher may have some or all of these features.
SURE-HOLD
®
Cup and Stemware Holder
Fold down the extra shelf on the left-hand or right-hand side of the
rack to hold additional cups, stemware or long items such as
utensils and spatulas.
USE WITH:
All cycles, except Rinse
Only
Anytime

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents