hager WBMSLL Quick Start Manual

WBMSLL
Slave / Extension unit
01 Hager Electro Pty. Ltd., Unit 17/2-8 South Street, RYDALMERE NSW 2116, AUSTRALIA
Safety instructions
Electrical equipment may only be installed and
assembled by a qualified electrician in accor-
dance with the relevant installation standards,
guidelines, regulations, directives, safety and
accident prevention regulations of the country.
Failure to comply with these instructions may
result in damage to the device, fire or other ha-
zards.
These instructions are an integral component of
the product and must be retained by the end
user.
Design and layout of the device
(3)
Figure 1: Front view
(2)
(3)
Figure 2: Rear view
The terminal block must be mounted in either
its original shipped position or on the rear of the
module by means of the enclosed cable tie.
(1) Button with status LED
(2) Retaining lugs for Rotoloc
(3) pre-assembled terminal leads
(4) Terminal block
Function
Correct use
- Extension unit to master devices WBMDUR,
WBMDUPB und WBME5A
- Suitable for indoor use only, but no drip and no
spray water.
(2)
(1)
(4)
® fastening