Table of Contents
Advertisement
Figure 5: Belt Cleaner Location & Chute Wall Cutouts
4.1 Locating belt cleaner
On both sides of chute, find pulley center point (A).
Measure radius of head pulley including lagging and belt thickness (B).
On the far side of chute, start from center point (A), measure the total distance
calculated in step 2 ( B + 13 mm [1/2 in.]), and draw an arc on chute wall.
On the operator side of chute, start from center point (A), draw an arc on chute
wall with a radius of (B + 13 mm [1/2 in.]). Draw an additional arc on chute wall
with a radius of (B + 28.7 mm [1-1/8 in.]).
M4082E ZA 2022-07 CSP1 S
19
Advertisement
Table of Contents
