Maintenance Instructions - PowerTech Promate 600 Owner's Manual

DC JACK (DC5521)
The Powerstation is equipped with 2 x 13V DC jacks
and can be used to operate 12V DC devices (maximum
5 Amps each).
Press DC button (2) On. The DC logo
•
appear.
Automatic over-current protection (at 5,5 ± 0.5
•
Amps).
The output power will be show on the LCD as well
•
as the indicative running time under the current
load.
Press DC button (2) Off after use.
•
DC Cigarette Lighter port
The Powerstation is equipped with a 13 V DC cigarette
lighter type outlet and can be used to operate most 12
Volts auto accessories and appliances (10 Amps
maximum) equipped with a cigarette lighter plug.
Press DC button (2) On. The DC logo
•
appear.
Automatic over-current protection (at 10.5 ± 0.5
•
Amps).
The output power will be show on the LCD as well
•
as the indicative running time under the current
load.
Press DC button (2) Off after use.
•
DO NOT PLUG A CIGARETTE LIGHTER INTO THE
OUTLET OF THE POWERSTATION.
Notes:
LED FLASLIGHT
1. Press light button (1) once for 50% lighting power
(1.5 Watts).
2. Press light button (1) a second time for 100%
lighting power (3 Watts).
3. Press light button (1) a third time for SOS flashing
will
mode.
4. Press light button (1) a fourth time to turn off the
light.
The output power will be show on the LCD as well as
the indicative running time under the current load.
VI.

MAINTENANCE INSTRUCTIONS

All batteries lose charge with time. AC recharge is
recommended after every use or every three months
when not in frequent use. Use the AC charger and
charge for the recommended time.
will
If the unit gets dirty, gently clean the outer surfaces with
a soft cloth moistened with a mild solution of water and
detergent. Do not use solvents or other chemical
cleaners. Periodically check the condition of charging
adapters, connectors, and wires. Replace any
components that may have become worn or broken.
These parts are not serviceable. Do not open or
disassemble. Service for Powerstation units is confined
to replaceable parts only. All other servicing should be
performed by a qualified service technician only.
4