Battery Installation / Status The Pocket Pro timer operates from a 9 volt alkaline or lithium battery. To install the battery, remove the cover on the back of the unit, connect the battery to the snap clip and reinstall the cover. A new battery will provide approximately 20 hours of use.
The time to the last shot will be displayed. To reset the Pocket Pro, press the start button again. It will automatically power down after 10 minutes of inactivity. The last shot string and the 2nd beep (Par...
Subsequent shots will not be recorded. The shot sensor is located next to the buzzer on the front of the case. When operating the Pocket Pro be careful not to cover the sensor opening with your hand. Doing so may prevent proper sound pickup and/or coupling of the buzzer.
There are ve control buttons on the front of the case. Looking at the front of the case left to right you will see REVIEW, NUMBER, SPLIT, 2nd BEEP, and POWER ON buttons. REVIEW After your last shot, you can review other shots by pressing this button.
SPLIT This button displays the di erence between the current shot and the previous shot. Holding down the SPLIT button while pressing the REVIEW button will review the split times. It will show the shot number for .5 seconds followed by the split time.
POWER ON This button is used to turn the Pocket Pro on. Power o is automatic after 10 minutes of inactivity. This button is slightly recessed to prevent accidental power on while in storage.
Need help?
Do you have a question about the POCKET PRO and is the answer not in the manual?
Questions and answers