Install The Mounting Plate-Poles Up To 4.5 Inches In Diameter - Cisco Catalyst IR8140 Heavy Duty Series Hardware Installation Manual

Mounting the Router
Figure 20: Mounting Plate Details
Item
1
2
3
4
5
Install the Mounting Plate Poles Up to 4.5 Inches in Diameter
Required Materials
• Mounting plate, carriage bolts, and clamp brackets included in
• 13-mm box-end socket wrench
To install the mounting plate on a vertical pole up to 4.5 inches (11.4 cm) in diameter:
Step 1
Select a mounting location on the pole and place the top and bottom pole clamp bracket (1) notches against the pole.
Step 2 Place one of the clamp brackets on the opposite side of the pole, aligning the clamp bracket holes with the top two carriage
bolt holes on the mounting plate.
Step 3 Insert a carriage bolt (5) through each of the top two carriage bolt holes on the mounting plate and through the holes in
the clamp brackets.
Step 4 Position each bolt in the clamp so that the bolt is next to the pole, as shown in the following figure.
Description Qty.
Carriage bolt holes 4
Bracket mount holes 8
Clearance holes, 3/4 in. 2
Pole clamp notches 2
Steel band strap slots 4
Cisco Catalyst IR8140 Heavy Duty Series Router Hardware Installation Guide
Install the Mounting Plate Poles Up to 4.5 Inches in Diameter
Pole Mount Kit, on page 26.
31