Table of Contents
Advertisement
Applying Power: Checklist
Troubleshooting
Options
FIG. 6
Detail of optional
Form "C" contacts
Operation/Maintenance
8
➤ Apply power to unit by closing the circuit breaker.
➤ Check TransEnd lights. Protection is active when all
lights are illuminated.
Call Joslyn Technical Support if you experience either
of these conditions:
•
Circuit breaker trips and cannot be reset
•
One or more lights on TransEnd are not illuminated
Our staff is available to support you around the clock.
Monday through Friday, 8:00 a.m. to 5:00 p.m. (EST),
call 800.238.5000 or 804.236.3300.
The TransEnd is available with these options:
•
Form "C" dry contacts for remote monitoring. Upon failure
of any phase, the relay's N.O. and N.C. contacts will
change state. The contacts are rated at 110VDC/125VAC with
maximum switching power of 30W DC/62.5VA AC.
•
18 inches of 3/4-inch nonmetallic flexible conduit and
a fitting that connects to the provided 3/4-inch hub.
•
3/4-inch x 3-inch nipple that connects to the provided
3/4-inch hub.
The only operational verification necessary on the TransEnd is to
observe that the lights are illuminated. There is no maintenance to
be performed on the TransEnd nor does the TransEnd contain any
user-serviceable parts.
™
JOSLYN
TRANSEND
INSTALLATION, OPERATION AND MAINTENANCE MANUAL ISSUED 6.01
®
PN 750-0064-Rev. 44
KK/1K/10.24.07
Advertisement
Table of Contents
