Advertisement
G41710_01-06.qxd
FRONT PANEL
The front panel of the HP-RB1 consists of:
REAR PANEL
The rear panel has 2 connections:
Attach the body of the unit to the underside of the dash using 2 screws on either side of
the control housing.
2
Get user manuals:
See SafeManuals.com
1/16/06
2:44 PM
(2) REMOTE BASS
CONTROL
1.
LED illuminated outer ring - which will glow (when the power connections are
made).
2.
Remote Bass Control - Rotate clockwise to increase the amount of bass/gain, or
counterclockwise to reduce the bass/gain. This control can be recessed by pushing
on the control.
GND +12V
(1) TWO-WIRE
LED HARNESS
1.
A two-wire harness allows control of the illumination of the LED. Connect the Red
+ wire to a illumination control output, or to a source of 12-15V power (current
draw is less than 20mA). Connect the Black or GND lead to a convenient power
ground. The control and illumination circuits are independent.
2.
A standard 3.5mm "mini" phone jack connects the gain control knob to the cor-
responding amplifier via a 2 conductor, 15 foot cable. Connect the other connec-
tor to the remote jack on the amplifier.
Note: The control can be removed from the housing if flush-mounting is desired.
Remove the two hex head screws at the side. Remove the 2 Phillip's head screws
securing the PCB. Remove the ring retainer on the front of the control, and then
remove the PCB.
Note: Before drilling any holes verify that there are no obstructions (wiring, ven-
tilation, etc) on the other side of the dash.
Page 2
MIN
MAX
LED
© 2006 Directed Electronics—all rights reserved
(1) ILLUMINATED RING
(2) 3.5mm "MINI"
PHONE JACK
Advertisement
