Advertisement
Supplier of TecNet & Maxon Communication Products
Programming of TP-8000BT Portables
Date:
August 27, 2014
Subject:
Programming of TP-8000BT Series Bluetooth Portables versus TP-8000
Series Portables
The programming of a TP-8000BT Bluetooth series may be slightly different than
programming a standard TP-8000 series portable. The radio will inadvertently go into a
Bluetooth (BT) mode when turned on and prohibit programming. The procedure listed
below will work around this issue.
1. Plug the ACC-8050E programming cable into the computer.
2. Go to the Device Manager on your computer and check which port is in use by
the cable. In this example (Figure 1) it is COM4.
________________________________________________________________________
11535 West 83
Telephone: 913-859-9515 ▪ Fax: 913-859-9550
Website:
T e c N e t I n t e r n a t i o n a l I n c.
Terrace ▪ Lenexa, Kansas ▪ 66214
rd
www.tecnetusa.com
Figure 1
Figure 1
▪ Email:
tecnet@tecnetusa.com
Advertisement
Table of Contents
Related Manuals for Tecnet TP-8000BT Series
Summary of Contents for Tecnet TP-8000BT Series
- Page 1 Date: August 27, 2014 Subject: Programming of TP-8000BT Series Bluetooth Portables versus TP-8000 Series Portables The programming of a TP-8000BT Bluetooth series may be slightly different than programming a standard TP-8000 series portable. The radio will inadvertently go into a Bluetooth (BT) mode when turned on and prohibit programming.
- Page 2 3. Next, run the ACC-805N programming software and select the correct port from the drop-down menu. There should be a checkmark next to the port number (Figure 2). Figure 2 4. Plug the 2-pin end of the programming cable into the jacks on the side of the radio.
Need help?
Do you have a question about the TP-8000BT Series and is the answer not in the manual?
Questions and answers